Thermoformer

EMAIL maker-thermoformer@engr.wisc.edu FOR SPECIFIC HELP ON THIS EQUIPMENT

This is an accordion element with a series of buttons that open and close related content panels.

Permit Upgrades

CoE permit (Lab Orientation OR red/green permit is sufficient) and paid materials fee for this semester are required. Our student staff are required to swipe your ID every time to verify.

Note: College of Engineering faculty and staff are not required to pay the materials fee though they still must have a CoE permit. 

Equipment Specs

Make Model Qty Type and Features Permit Required
Formech 508DT 1 2x Reducing Windows (5 x 5″ & 11 x 11″ Aperture) Red Specs
FTM Inc. FS-24 1 2 ft. Strip Heater for Bending Plastics (1/2″ wide heated area). For use with plastics .100″ up to 1/2″ thick. Blue

Thermoformer Managers

Do you have a question about the Thermoformer?

Below is the schedule of our most knowledgable staff when it comes to Thermoformer. Find a time when they’re working and then come in and ask the front desk staff to help you find them.

Note: Make sure to only come for help during the Makerspace hours here.

Or e-mail maker-thermoformer@engr.wisc.edu 

Support Staff Date Start Time End Time
Brett Prussack 10/19/2021 11:00 AM 02:00 PM
Brett Prussack 10/21/2021 11:00 AM 02:00 PM
Brett Prussack 10/22/2021 12:00 PM 03:00 PM
Brett Prussack 10/26/2021 11:00 AM 02:00 PM
Brett Prussack 10/28/2021 11:00 AM 02:00 PM
Brett Prussack 10/29/2021 12:00 PM 03:00 PM